The smart unit automatically sprays fragrance when a shadow has been cast upon a sensor.
To conserve the refill, the unit automatically enters a lock-out mode once it has detected motion and sprayed. The lock-out mode for Sense & Spray is 20 minutes. The lock-out mode for Sense & Spray (with 360° design) is 15, 20, or 30 minutes depending on the switch setting.
When in lock-out mode, the sensors are off and the unit will not automatically spray. After the lockout mode time has expired, the unit is again ready to sense motion.
For an instant burst of Glade® fragrance anytime, press the boost button on the top of the unit.
Use only Glade® Sense & Spray® refills in this unit.
For best results, place unit upright on a flat surface where upward spray will not be obstructed. Place unit within five feet of traffic flow.
The sensor may not respond if:
The room is too dark. Ensure there's sufficient lighting to allow a shadow to be cast upon sensor.
The unit is placed directly on or in a light source, especially sunlight. Move the unit out of the bright light.
Sensor on the front of the device is blocked by objects. Position the unit so that the sensor is unobstructed.
Keep the unit pointed away from you and others during assembly. It automatically sprays a burst of fragrance after assembly to show it is working properly.
Sense & Spray
Lift front cover. Lay canister into position over the tan tab. Snap canister into place. You will hear a click to know the refill has been inserted correctly.
Pull and discard red tab to activate batteries.
To replace canister, lift front cover and remove the empty canister. To install new canister, follow assembly instructions in steps 2–3.
To replace batteries, lift front cover. Insert two new AA batteries.
NOTE: Be sure that replacement batteries are positioned correctly. Unit will not function if batteries are installed backward.
Sense & Spray (with 360° design)
Hold the bottom of the device securely in one hand and twist top half counterclockwise and lift off. To initially activate the batteries, open the device and remove the red tab. To close, align the refill, batteries and two square black tabs on bottom housing with the slots on the top housing and close firmly until top and bottoms housings touch, leaving no gap. Keeping firmly closed, twist top clockwise to lock, lining up the seams on the top and bottom.