Glade logoProduct Collections / More Sprays
Glade® Sense & Spray® Automatic Freshener
Motion-activated fragrance for your home.
The innovative Glade® Sense & Spray® Automatic Freshener detects when someone passes by, instantly releasing a burst of fragrance into the air. To conserve the refill, the smart unit will then go into a lock-out mode, where it will not spray fragrance again for 20 minutes. Refills are available in a variety of Glade® fragrances and last for weeks.
Benefits
- Glade® Sense & Spray® Automatic Freshener Starter Kits are available in NEW! Tough Odor Solutions Clear Springs™, Clean Linen™ and Apple Cinnamon. For the new design of Glade® Sense & Spray® Automatic Freshener, Starter Kits are available in NEW! Hawaiian Breeze® and NEW! Lavender & Vanilla.
- Glade® Sense & Spray® Automatic Freshener refills are available in Apple Cinnamon, Clean Linen™ and Hawaiian Breeze®, as well as NEW! Tough Odor Solutions Clear Springs® and NEW! Lavender & Vanilla.
- Tough Odor Solutions Clear Springs® eliminates even the toughest cooking, pet and bathroom odors, while leaving a refreshing scent so your home smells fresh and clean.
Directions
How does it work?
Usage Instructions- The smart unit automatically sprays fragrance when movement has been detected.
- The unit is in active mode and ready to detect motion when the light blinks every five seconds.
- To conserve the refill, the unit automatically enters a 30-minute lock-out mode once it has detected motion and sprayed (light is solid).
- The sensor is off and the unit will not automatically spray while in lock-out mode. After 30 minutes, the unit is again ready to sense motion (light blinks every five seconds).
- To override lock-out mode or to get an instant burst of Glade® fragrance anytime, press the boost button in the front of the unit.
- Use only Glade® Sense & Spray™ refills in this unit.
- For best results, place unit upright on a flat surface where upward spray will not be dispensed onto objects. Place unit within five feet of traffic flow.
The sensor may not respond if:
- The room is too dark. Ensure there's sufficient lighting to allow a shadow to be cast upon sensor.
- The unit is placed directly on or in a light source, especially sunlight. Move the unit out of the bright light.
- Sensor on the front of the device is blocked by objects. Position the unit so that the sensor is unobstructed.
CAUTION: Keep the unit pointed away from you and others during assembly. It automatically sprays a burst of fragrance 20 seconds after assembly to show it is working properly.
Assembly instructions
- Lift front cover.
- Lay canister into position over the tan tab.
- Snap canister into place. You will hear a click to know the refill has been inserted correctly.
- Pull and discard red tab to activate batteries.
Replacing canister
- Lift front cover and remove the empty canister. To install new canister, follow assembly instructions in steps 2–3.
Replacing batteries
- Lift front cover.
- Insert two new AA alkaline batteries. NOTE: Be sure that replacement batteries are positioned correctly. Unit will not function if batteries are installed backward.
Safety & Precautions
CAUTION: CONTENTS PRESSURIZED. Do not puncture or incinerate. Do not expose to heat or store above 120 degrees F, or place on a heated surface as container may burst. Store in a cool, dry place. Do not place unit below any electrical outlet and/or light switches.
EYE IRRITANT. Spray contains fragrance and ethanol. Do not spray toward face. Avoid eye contact or excessive inhalation. If eye contact occurs, flush eye thoroughly with water for 20 minutes. If irritation persists, consult a physician. Do not use in asthma or other medical inhalers. Do not use in small, confined pet areas without adequate ventilation.
Keep out of reach of children and pets.