The smart unit automatically sprays fragrance when a shadow has been cast upon a sensor. To conserve the refill, the unit automatically enters a lock-out mode once it has detected motion and sprayed. The lock-out mode for Sense & Spray is 20 minutes. When in lock-out mode, the sensors are off and the unit will not automatically spray. After the lockout mode time has expired, the unit is again ready to sense motion. For an instant burst of Glade®
fragrance anytime, press the boost button on the top of the unit. Use only Glade®
Sense & Spray®
refills in this unit.
For best results, place unit upright on a flat surface where upward spray will not be obstructed. Place unit within five feet of traffic flow.
The sensor may not respond if:
The room is too dark. Ensure there's sufficient lighting to allow a shadow to be cast upon sensor.
The unit is placed directly on or in a light source, especially sunlight. Move the unit out of the bright light.
Sensor on the front of the device is blocked by objects. Position the unit so that the sensor is unobstructed.
CAUTION: Keep the unit pointed away from you and others during assembly. It automatically sprays a burst of fragrance after assembly to show it is working properly.
Sense & Spray—Lift front cover. To avoid misuse, make sure lever is pushed up before inserting refill. Lay cartridge into position over the brown tab. Snap cartridge into place ensuring brown tab protrudes from under the refill. You will hear a click to know the refill has been inserted correctly. Pull and discard red tab to activate batteries. To replace cartridge, lift front cover and remove the empty cartridge. If cartridge is not clicked into place, upon activation product may leak onto and damage surface. To install new cartridge, follow assembly instructions in steps 2–3. To replace batteries, lift front cover. Insert two new AA batteries. NOTE: Be sure that replacement batteries are positioned correctly. Unit will not function if batteries are installed backward.